Page 1 of 1

Edit Sys-Spec graphics settings

Posted: Thu Jan 07, 2021 12:18 pm
by TinyTech_Online
Hi there!

I know that this may be a very trivial question however I have been wondering for a while how to edit the 'graphics setting' levels found within the engine? I am working on a first person adventure game and due to the inherent hardware requirements in order to run such a large and open environment on lower level systems, I want to be able to customise the levels of anti-aliasing, water tessellation, reflections quality, and so on as so I can provide an appropriate balance between quality and performance. ATM I am able to edit these within the sandbox and everything works fine however these obviously are not assigned to any particular graphics level.

I assume there must be a particular .xml file or folder where I can customise the values for these? or if someone could guide me to how I could go about this it would be a massive help

Thank you for your time!

Re: Edit Sys-Spec graphics settings

Posted: Thu Jan 07, 2021 4:13 pm
by VascotiaStudios
Those are under the Engine folder where you installed the engine, not the project. In the CvarGroups folder inside engine.pak.