Debugging flowgraphs

#1
i have been trying to debug flowgraphs in the project after watching tutorials in cryengine 5.3 and 5.1, but haven't been able to do so. I have enabled and disabled debugging many times and can't come to a way to do it. How should i proceed ?

Re: Debugging flowgraphs

#2
Debugging works fine here. So there is something wrong with your setup. Just try to create a new flowgraph. Add a "start node" and link the output to an "any node". Then activate the debugger and jump ingame (ctrl + g). If everything is setup correctly, you should now see that the connection between the "start" and the "any node" is yellow (means that it was triggered).

- Jannis

Who is online

Users browsing this forum: No registered users and 3 guests